FF Framed Polka Dotted Pinwheels

FF Framed Polka Dotted Pinwheels

2-14-19 thru 3-2-19

--1 partner

--1 block to each partner

--9-inch block when mailed

CUTTING FABRIC

Pinwheel HSTS (half square triangles)

(2) 3 X 3-inch same polka dotted print

(2) 3 X 3-inch tone-on-tone white polka dot print or white with small far spaced colored dotted print or just plain white fabric (must be mostly white to work for this block)

Borders

(12) 2 ½ X 2 ½ squares of different prints (these can be from all different prints or up to 4 squares alike – small prints are best) suggested 1930’s prints, or floral prints, any small print really

ASSEMBLY

(use ¼ inch seam allowance)

Take one 3-inch square white fabric and one 3-inch square polka dotted print fabric. Draw a diagonal line on the back side of white fabric from upper left to lower right. Stack the 2 pieces right sides together. Stitch on either side of the line ¼ inch. Cut on drawn line. Press HST and square up to 2 ½”. Stitch the 2 together. Repeat this process for the other half of the Pinwheel. (Sometimes it is best to make all 4 parts and lay them out before stitching the pinwheel together so that you get the right formation….looking at the picture helps me too.)

Stitch both halves of the pin wheel together. Press

Take 2 border prints and stitch them together. Make 2 pairs of these. Stitch one pair on the left side of the pinwheel, and one on the right side of the pinwheel. Press.

Sew 4 different border charms for the top row, and 4 for the bottom row. Attach these to top and bottom of pinwheel unit. Press

If we have enough interest in this swap we will do it several rounds.

Questions and concerns welcome, please post below.

Swap-on!